Welcome
Preparation
Print
Result
Theme
Dark Theme
Light Theme
Finishing touches
This step can require a lot of patience. If your print didn't need supports or any sanding, then it is good to go. Rip it off the pad with some force or use a sharp blade and cut it loose. However, if you had extra stuff on your object after you pulled it from the pad, you'll most likely have to remove supports and/or sand it. Removing supports is a tedious process. You''ll have to cut and pull with some needle nose pliers or something similar to get rid of them. Sanding is only if the model is rough after the print.
Next Image